Maintenance And Cleaning; Working Advice - Würth TBS-M Traducción Del Manual De Instrucciones De Servicio Original

Slide the screwdriving attachment over the screwdriv-
ing bit 1 to the stop on the spindle collar of the drive
tool. Tighten fastening screw 10 with an enclosed key.
Setting the Screw Length
Press and hold the quick-action locking screw 5 and
slide the stop 8 until the desired value is indicated on
the scale 6. The stop is affixed at this position through
the locking screw 5.
Setting the Screw-in Depth
7
Adjustment –: Lesser screw-in depth, screw head
protrudes.
Adjustment +: Greater screw-in depth, screw head
immersed.
The required screw-in depth depends on the material,
and is best determined through practical trial.
Inserting Screw Strips
Slide the screw strip into the guide 9. The 1. screw of
the screw strip must rest against the transport hook.
To ensure proper functioning of the auto-
matic transport mechanism, a return stroke
must be performed before beginning the
screwdriving work each time the screw strip
is inserted/exchanged, in order to bring the
1. screw into the working position.

Working Advice

 Check the rotation direction of the drive tool before
beginning the screwdriving work. The screwdriving
attachment may only be operated in the "clock-
wise rotation direction".
 Always drive in screws at a right angle to your
work.
 Screws already driven in cannot be driven out or
retightened with the screwdriving attachment.
The desired screw-in
depth can be variably
adjusted by changing
the setting of the
knurled screw 7 on the
rear of the device.
 For proper functioning of the device, only screw
strips according to WÜRTH specification are
allowed to be used.
Switch the drive tool 4 on and apply the stop 8 against
the screwing location. Apply the screwdriving attach-
ment with uniform pressure against the material surface
until the clutch of the drive tool disengages upon reach-
ing the preset screw-in depth.
By briefly lifting the stop 8 from the material surface,
the next screw is transported into the working position.
Note: When the screwdriving bit slips in the head of
the screw, lift off the screwdriving attachment immedi-
ately, otherwise the screw head and the screwdriving
bit will be damaged.

Maintenance and Cleaning

 The device is maintenance-free. When soiled or
dirty, clean the moving parts from dust or debris.
Do not use lubricants.
If the device should fail, despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by a Würth masterSERVICE.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the device.
The current spare parts list for this device can be
viewed on the Internet at
"http://www.wuerth.com/partsmanager" or be
requested from your next Würth branch office.
Guarantee
For this Würth device, we provide a guarantee in
accordance with the legal/country-specific regulations
from the date of purchase (verified by invoice or deliv-
ery document). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the device is sent undis-
assembled to a Würth branch office, your Würth sales
representative or an authorised customer service agent
for Würth compressed-air and power tools.
8