Personnel Qualification; Special Compliance; Conventions; Word Conventions - STA-RITE vx Manual Del Producto

1.5.1 Personnel qualification

Qualification and protection restrictions foreseen for the operators
OPERATOR QUALIFICATION
Carrier Knowledge and
command of the
chapters:
- "General informa-
tion"
- "Description"
- "Installation"
Installer Qualification
complying with the
provisions of the
Country of installa-
tion, knowledge and
command of the
chapters:
- "General informa-
tion"
- "Description"
- "Installation"
User Knowledge and
command of the
chapters:
- "General informa-
tion"
- "Description"
- "Use"
Maintenance Fitness acknowl-
man edged by SACI
PUMPS,
knowledge and
command of the
chapters:
- "General informa-
tion "
- "Description"
- "Maintenance"
Demolisher Knowledge and
command of the
chapters:
- "General informa-
tion"
- "Description"
- "Dismantling"
Danger The machine safely operates when used by
personnel
instructions contained in this manual and
on board the machine.
All the operations shown by this manual
must only be carried out by qualified
personnel equipped with the protecting
means provided for by this manual
SACI PUMPS is not liable in
case of accidents deriving from the use of
non qualified and non authorised personnel
and by the non compliance to the instruc-
tions present in this manual an on board
the machine.
RECCOMENDED
INDIVIDUAL
PROTECTION
MEANS
Protective shoes
and gloves
Protective shoes
and gloves
Protective shoes
and gloves, high
temperature
protecting overall
and gloves
Protective shoes
and gloves
Protective shoes
and gloves
qualified according to

1.5.2 Special compliance

The use of personnel having a qualification different from the
specified one may involve risks for people and/or the machine.

1.6 Conventions

1.6.1 Word conventions

The manual adopts the following conventions
- Machine
- Authorised technician :
- Skilled technician

1.6.2 Typographical conventions

Danger
Attention

1.7 Expected uses

1.7.1 Expected uses
The machine has been designed, manufactured and protected to
allow the conveying, circulation and the increase in pressure of
the following types of fluids:
- Water having a -15 °C to 120 °C temperature (for temperature
lower than 0°C the addition of a fit quantity of ice-preventing
agent is expected)
- Water glycol mixtures (or ice-preventing products having
chemical physical characteristics similar to glycol) with a glycol
percentage up to 50%
- Liquids and waters chemically compatible with the materials that
the
are part of the machine
- Neutral, non explosive fluids having a viscosity similar to water
The machine has been designed, manufactured and protected to
allow a fluid delivery depending on the required head (see
"Product specification")

1.7.2 Expected modes of installation

The machine has been designed, manufactured and protected to
be installed both:
- Indoor
- Outdoor with a protection from atmospheric agents
The machine has been designed, manufactured and protected to
be used under the following atmospheric conditions:
- Temperature range: -15 °C to +40 °C
- Allowed relative humidity range: 30 to 90%
: motor-pumps
"Product specification" "
person authorised
PUMPS to carry out on the
machine operations not documented
by this manual
: person authorised to carry out on the
machine operations not documented
by this manual after contacting
SACI PUMPS
Danger indications show the procedure
whose non or partial compliance may
cause physical damages to the operator
Attention indications show the procedures
whose non or partial compliance may
cause damages to the machine or to the
equipment connected to it
Note indications contain important informa-
tion highlighted outside the text to which
they refer
specified in the
by SACI