koban KPM3 ENERGY SMART Manual De Instrucciones página 28

Press this key to display different kinds of electrical parameters under the measurement
➢
interface
Under the programming interface :1, press this key to switch to display the same Level of
➢
programming parameters 2, press this key to modify the programming parameters
5.2 Measurement parameters view
1
S
2
3
Show A phase voltage is 220V
➢
Show B phase voltage is 220V
➢
Show C phase voltage is 220V
➢
➢ In the three-phase four-wire connection mode,
display the three-phase line voltage by
switching
Show AB line voltage is 381V
➢
Show BC line voltage is 381V
➢
Show CA line voltage is 381V
➢
➢ In the three-phase four-wire connection mode,
the three-phase voltage is displayed by
switching
Show A phase current is 50A
➢
Show B phase current is 50A
➢
Show C phase current is 50A
➢
Show total active power is 16.50 kW
➢
Show total reactive power is 28.58 kVar
➢
Show total apparent power is 33.00 kW
➢
In the three-phase four-wire connection mode,
➢
the phased active power is displayed by
switching
4