PHARO SkyLine 26017000 Manual De Instrucciones página 16

uSED SyMBOLS/ TEChNICaL DaTa/ NOTE
Fitting items
Tools/ Montage
Dimensions Diagramm
hnical Data
Tec
Caution Water!
Before drilling the bottom hole pay attention
if water supply pipes cross this area.
Note
Informs the personnel concerned of informa-
tion with important contents to be observed.
Water connection DN 1
hot water 1/2"
Water connection DN 1
cold water 1/2"
Montage
1. 1.
Operation, spare parts and flow capacity
diagramm see on page 2 - 4.
Spare part numbers with XXX identification must be
replaced by the code number relating to the finish of
the product.
000 chrom
• identification in flow diagram: From • the function is
guaranteed.
Operation and function from handshower
see on enclosed brochure.
Dimensions
The installation dimensions stated in this installation
instructions are ideal for people of approximately
1800 mm in body height.The dimensions can be
altered if required. In this case you will have to attend
to the minimum height of 2200 mm from shower
tray floor, and alter all the required measurements as
necessary.
If the height of water connection are outside of the
illustrated range, the drill measurements must be
adjusted accordingly. (attention for minimum room
height of 2200 mm from tub-floor).
Flush through the supply pipes(DIN EN 1717).
8
Minimum flow pressure
Operating pressure
Recommended operating pressure
Test pressure
(1 MPa = 10 bar = 147 PSI
Hot water temperature
Safety stop
Flow capacity at 0, MPa
Overhead shower
Neck shower
Handshower
Body showers
Hand- + Overhead shower
Hand- + Neck shower
Body- + Overhead shower
Body- + Neck shower
use only free from acetic acid
Flow heater
Applicable for flow heaters at min. 24 kW and 0.2 MPa
flow pressure before the Shower panel and a mini-
mum through flow of 11 l/minute. Only one consumer
possible, not two simultaneously.
Pressure differences
The pressures of the cold and hot water connections
must be balanced.
Maintenance
The non return valves must be checked once a year
(DIN EN 1717).
0,2 MPa
0,2 - 1,0 MPa
0,25 - 0,5 MPa
1,6 MPa
max. 70° C
38° C
14,1 l/min
13,0 l/min
13,4 l/min
13,6 l/min
22,3 l/min
21,3 l/min
21,7 l/min
21,2 l/min