Remote Control; Remote Control Id Setting - BenQ LU9915 Guia De Instalacion

Remote control

COMPUTER 1
COMPUTER 2
Numeric buttons

Remote control ID setting

You can set the remote control ID to control the specific projector.
Please set projector ID (from 01 to 99) by using the OSD menus. After setup different ID, the
remote control will only control the matched projector .
Press ID SET + MENU keys together for 5 seconds, the remote control backlight will flash one
time, then into the ID Set mode.
Again click ID SET + MENU keys for 5 seconds (backlight will flash 1 time) to release ID SET
Mode.
After into the ID Set Mode, press ID SET key for 3 seconds.
The remote control LED light will flash and backlight will light. In the meantime, press number to
set the remote control ID.
For example, for setting remote control ID to "01", please press 0 key for 1 second (LED light
will flash 3 times then back light off), then press 1 key for 1 second (LED light flash 3 times then
backlight off).
For setting remote control ID to "19", please press 1 key for 1 second, then press 9 key for 1
second.
ON
FOCUS +/-
Up
Left
MENU
MENU
AUTO PC
1
HDMI 1
4
3G-SDI
7
DisplayPort
CLEAR
OFF
ZOOM +/-
TEST PATTERN
LENS-SHIFT
ENTER
Right
ENTER
Down
EXIT
EXIT
BLANK
STATUS
ASPECT
2 3
DVI
5 6
HDMI 2
HDBaseT
8 9
0 ID SET
FREEZE
7