CAPITAL SPORTS Infinity Track 6.0 Touch Manual De Instrucciones página 57

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

P1-P36 are preset programs. Only the time can be set here. Press
the [+] or [-] button to change the value. The time can be set between
5-99 minutes. The default setting is 30:00 minutes. Press the „MODE"
button to return to the default settings.
When you have set everything, press START. The display starts a
5-second countdown and then emits 5 tones. The treadmill starts
slowly and then continuously increases the speed until the preset or
entered speed is reached.
While running, press the [+] or [-] button or one of the speed buttons
to set the desired speed.
Note: In the P1-P36 programs, speed and gradient are divided into 10
segments. Each segment lasts the same length. The adjusted speed is
only available in the current segment. 3 seconds before the program
moves to the next segment, a 3-fold signal tone sounds. When the 10
segments are finished, the motor stops and a signal sounds.
When running, press the START button to stop the treadmill. Press
START again to continue running. The recording data is retained.
Press the STOP button while running, the treadmill stops slowly and
returns to its initial state.
Note: You can remove the safety key at any time to stop the treadmill.
The display then shows the error message [E7] and a warning signal
sounds.
The control panel is constantly monitored. If faults occur, an error
message appears on the display and a SIgnal signal sounds.
EN
57

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

10032953

Tabla de contenido