Stiga SENSORSCOPE T1830 Manual Del Usuario página 4

Measure and mark the center on the underside of each table half. These are your sensor locations. Note: It may be
necessary to move your sensor toward the end or toward the middle of the table to miss support structure
of your table. This will not affect the function of your scoring unit. Install a sensor to the underside of each
table half at the marked location using the screws provided.
Route sensor wires toward main housing location as shown and secure them to the bottom of table using clips
provided. Use Figure 2.1 as a guide but you will need to make sure the wires will not be pinched by moving parts
when you open and close your table.
Attach the Remote Controller to the table's side apron using the adhesive backing on the controller , see Figure
2.2. Route controller wire toward the Main Housing and secure to the bottom of the table using the clips
provided as shown in Figure 2.1.
Insert cable from Sensor A to Slot A, Sensor B to slot B and Net sensor to Net Slot on main housing. See Figure 2.3.
Figure 2.2
Figure 2.3
CAUTION! Always unplug these wires
before folding the table.
All Rights Reserved
©2014 Escalade Sports
Install Sensors
Controller
Main Housing
4
TOP VIEW OF TABLE TENNIS TABLE
Sensor A
(Home Side)
Sensor B
(Away Side)
Figure 2.1
For Customer Service Call 1-800-457-3373
Controller Wire
Sensor Wire
Wire Clips
Sensor