Publicidad
Idiomas disponibles
Idiomas disponibles
Drawing B
3. Get access to the set-up mode of TIME/DISTANCE/CALORIES/Target PULSE. When you are in each set-
up mode. For instance the time set-up, when the time value is blinking, you can press "UP and DOWN"
button to adjust the number. Press "Mode" button for confirmation and skip to next set-up. The set-up of
DISTANCE & CALORIES is the same as TIME set-up.
4. When you are in Target PULSE mode, the main screen will show "AGE", PULSE screen show "TARGET
value (220-AGE)". At the time you can press "SET" button to change the value of AGE and TARGET
shown as "Drawing D". When the set-up is completed, press "MODE" button to confirm and skip to TIME
screen. Continuously press "MODE" button will act this circle. If you do not enter the RPM and PULSE
signal or manual set-up time over 4 minutes in this mode, it will be skip to SLEEP mode shown as
Drawing D
5. After entering RPM value, and setting up the TIME, DISTANCE, CALORIES. In SCAN mode shown as
"Drawing F". RPM/SPEED/TM/DIST/CAL/PULSE will skip to display in every 6 seconds. The order is as
follows.
Drawing F
6. You can also press "Mode" button to select single function display except RPM & SPEED function. The
RPM & SPEED function will switch display.
7. Except the SPEED / RPM cannot set up other function mode. For example when set-up is completed of
TIME,DISTANCE,CALORIES,TARGET H.R., enter RPM, the monitor will count down till 00:00 is achieved,
and come out 4 times "Bi" sound for 8 seconds, then the value will be count up from 00:00 right away.
8.
RECOVERY
(1)When the user presses "RECOVERY" button, the RECOVERY function is active. At this time only PULSE
and TIME is working, other functions will not be displayed, and the Sensor Input is not available. TIME starts to
Drawing C
Drawing E
Publicidad
