Care And Cleaning; General Cleaning; Troubleshooting Guide - Hamilton Beach Commercial 908 Serie Manual De Operación

Ocultar thumbs Ver también para 908 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14

Care and Cleaning

General Cleaning

Do not allow food residue to dry on any part of
Blender. Wash and rinse Jar and Base after each
use, or whenever it will not be used again within
1 hour, as follows:
1. Remove Jar from Base, and then remove Lid.
Add cleaning solution to Jar. Use a washing
solution of hot water (less than 115°F/46°C) and
a nonsudsing detergent. Use recommended
amount of detergent.
2. Scrub and flush out Jar. Empty Jar.
Maintenance
Inspect Blender and its various parts and replace as follows:
Daily
Unplug Blender, remove Jar from Base, and then inspect Jar with cutter assembly
for wear, nicks, and broken or loose blades. Replace if necessary. If blades are
loose, discontinue use immediately and replace Jar. Do not attempt to repair or
tighten cutter assembly. See "Technical Services."
Weekly
Unplug Blender, and then inspect power cord insulation and power plug for
cracks. See "Technical Services."
Quarterly
Replace Jar as needed if inspection finds wear, nicks, or broken or loose blades.
See "Technical Services."

Troubleshooting Guide

Problem
Solution
Blender fails to start,
• Check to see if unit is securely plugged into an electrical socket.
or stops while it is
• Check to see if fuse for electrical socket has blown or if a circuit breaker
running and cannot be
restarted.
• If the motor stops during operation due to overheating, unplug and allow the
• Check to see if Lid tab is aligned over Post.
• Check to see if Lid flange is fully seated against the top of the Jar.
Ingredients will not
• Check to see if enough liquid has been added to ingredients. Mixture should be
mix properly.
• Solid pieces are too large. Pieces should not exceed 1" (25-mm) cubes.
• Jar is too full. Do not fill past highest graduation marking.
• Blades are not sharp or are damaged. Inspect Jar and cutter assembly daily.
• Check to see if cutter assembly is installed securely.
• Select speed to create a fluid blend.
has tripped.
unit to cool down for 15 minutes. Plug unit back in after 15 minutes to resume
normal operation.
fluid and free-running at all times.
Replace Jar and cutter assembly as needed if inspection finds wear, nicks, or
broken or loose blades. See "Technical Services."
3. Fill Jar 1/4 full with fresh washing solution and
place it on Base.
4. Replace Lid on Jar and run Blender on HIGH (2)
speed for 2 minutes.
5. Repeat Step 3 using clean rinse water
(95°F/35°C).
6. Wipe down Jar and Lid with a soft cloth
or sponge, dampened with fresh washing
solution.
7. Wipe Base with a damp cloth or sponge.
Base contains electrical components; do not
immerse in water. Do not use a high-pressure
washer or use a dishwasher to clean Base.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hbb908r

Tabla de contenido