Start-Up Procedure - Lorell LLR81954 Guia De Inicio Rapido

STEP 7: Attach the leg assemblies
14 . Align the holes in the U-channel 12 with the pilot holes in the
wood screws
worksurface. Attach it using (8) or (10) wood screws
the groove near the motor as shown below. Align the holes in the control box
with the pilot holes in the worksurface. Attach it with (2) wood screws
18 with the pilot holes near the front of the worksurface.
holes in the hand switch
Attach it with (2) sheet metal screws
19 . Attach it with (1) wood screw 14 . Attach the wire management J 16 to the
worksurface in the location shown below using (1) wood screw
provided.
STEP 8: With the help of an assistant, stand the workstation upright in its final
location. Level the workstation if required by turning the leveling glides clockwise
(from the top) on the low corners of the unit.
2
14
16
13
MFG. DATE & SERIAL
NUMBER ARE ON THE
STICKER LOCATED ON
THE CONTROL BOX
2 and 7 to the worksurface 1 using (16)
14 . Trap the switch wire in
15 . Insert the switch wire into the cable clamp
14 . No pilot hole is
14
17
7
15
17
18
19
14
12
14
ELECTRIC HEIGHT ADJUSTABLE WORKSTATION OPERATING INSTRUCTIONS
CAUTION! TO PREVENT PINCHING OR COLLISION, MAKE SURE THAT
YOU, YOUR FINGERS AND OTHER OBJECTS ARE AT LEAST 3/4" FROM
13
THE TABLE'S EDGES AND TRAVEL PATH.
14 . Align the
STARTUP PROCEDURE:
• Plug the power cord from the control box into a standard 110-volt receptacle.
• A power surge protector is recommended.
• Press the down button until the worksurface bottoms out and the control box
beeps (3) times.
• The workstation is now ready for use.
TROUBLESHOOTING:
If you are having a problem with the table operation, E-mail Lorell@sprich.com
or fax 404-472-9063.
Please provide the following information:
1. Full name
2. Physical address-do not include P.O. Box as our carriers cannot deliver
to P.O. Boxes
3. Phone number
4. Model number
5. Part number
6. Invoice #
7. Date of purchase
NOTE: Our policy is to send all parts requests normal ground transportation. If your
requirements are to have these parts via overnight/next day, please provide your designated
carrier an account number. Replacement panels are not available. If damage has occurred
during shipment, please return the entire unit to place of purchase for credit and replacement.
Original invoice may be required.
SPECIAL NOTE: DO NOT USE ANY ABRASIVE
CLEANERS ON THIS UNIT.
1
STEP 7
PAGE 3 OF 4