Eureka HELIOS Serie Instrucciones De Manejo página 34

4.3 GRINDING REGULATION
To set the grinding, use the regulation knob (3), turning it clockwise to grind finer or
counterclockwise to grind it coarser (like displayed on the knob). There is no block;
grinding regulation must be gradually performed, grinding a little bit of coffee each 2 steps
maximum.
ATTENTION
If the knob is turned a full round when the motor is not working, the grinder can
stop
4.4 DISPENSING SYSTEM REGULATION
Considering the filter holder and the type of coffee, set the dispensing chute (7) in height
and grade so to have a correct coffee outlet.
4.5 REGULATE THE FILTER HOLDER FORK
• The fork is suitable to all filter holders in the market.
• With a crosshead screwdriver, loosen the fixing screw of the filter holder fork (5).
• Raise or lower the fork depending on the filter holder size.
• Once you find the right position, tighten the fixing screw of the fork (5).
4.6 FUNCTIONING
Select the dose to be dispensed trough the buttons (B), (L) or (C). Lay the filter holder on
the fork (5), so to have it right under the chute (7) (Fig. 7) and push it forward so to press
the micro-switch (6).
Dispensing stops when the set time is over and the grinding time returns to the original
pre-set time and the grinder is ready to work again. If the continuous mode is on (H) the
dispensing lasts the same time you keep the microswitch pressed (6).
When you release the button (6), continuous mode stops and the grinder sets back the
automatic dose selection
ATTENTION
It's possible to stop the automatic dispensing before the grinding time is over.
During dispensing, use the filter holder to press the microswitch so to stop
dispensing (5):
• Press again the microswitch (6) to restore the dispensing for the remaining time;
• Press any dose button to stop dispensing. The grinding time comes back to the
one previously set.
14
EN