Display Setting - Yamaha BD-S677 Manual De Instrucciones

SETUP menu
Connection Test
You can perform an internet connection test. If the test is
failed, please check "IP Setting" (p. 32) and perform the
test again.
IP Setting
You can configure the network settings.
Auto* Select to automatically configure the network
settings of this Player with the DHCP server.
Manual Select to configure the network settings (IP Address,
Subnet Mask, Default Gateway, and DNS) manually.
Hints
– Numeric keys Enters characters.
– 2/3
Moves the highlight.
– CLEAR Deletes a character.
– ENTER
Saves the settings and exits from
the menu.
Proxy Setting
You can set Proxy Setting. Set to Disable for normal use.
Set to Enable to set the proxy setting.
* Sets proxy server to disable. Select this item when
Disable
proxy server is not used.
Enable Enables proxy host and proxy port setting.
Proxy Host Sets proxy host.
Proxy Port Sets proxy port.
Network Control
Sets the control for devices, which are connected via
Ethernet, to On/Off. When On with filter is selected, you
can specify the MAC addresses of the network devices
that will be permitted access to this Player. This Player
employs Yamaha Network Control protocol (YNC).
On * , On with filter, Off
Notes
– When Network Control is enable, power
consumption during standby mode increases due to
network control function.
– When set to On, the system startup time is
decreased.
Network Standby
You can select whether this Player can be turned on from
other network devices such as "AV CONTROLLER"
(p. 22).
*
On, Off
Note
– This setting is available only when Network Control
is enabled.
DMC Control
You can select whether to allow DLNA-compatible
Digital Media Controller (DMC) (p. 15) to control this
Player.
*
Enable , Disable
32
En
BD-Live Connection
You can set access restriction to BD-Live contents.
Permitted
Allows all BD-Live discs to connect the network.
Partial Allows only discs with owner certification.
*
Permitted
Prohibited Prohibits all BD-Live discs to connect the network.

■ Display Setting

The default settings are marked with "
TV
3D Output
You can select 3D or 2D video output from this Player.
Auto* This Player automatically selects 3D or 2D videos.
Off This Player always selects 2D videos.
Note
– Even if you set "3D Output" to "Auto" and play
back a Blu-ray 3D Disc, this Player selects 2D
images depending on the setting of TV, etc.
TV Screen
You can set the screen aspect ratio of the connected TV,
and adjust the video output.
If you switch your TV (i.e. because you have bought a
new one) and the screen aspect ratio of the connected TV
changes, you will have to change the TV Screen setting.
16:9 Full
Select this when this Player is connected to a TV
with a 16:9 screen. When a 4:3 aspect ratio video is
played back, the video is displayed as shown below.
* Select this when this Player is connected to a TV
16:9 Normal
with a 16:9 screen. When a 4:3 aspect ratio video is
played back, the video is displayed as shown below.
4:3 Pan Scan Select this when this Player is connected to a TV
with a 4:3 screen. When a 16:9 aspect ratio video is
played back, the video is displayed as shown below.
4:3 Letter Box Select this when this Player is connected to a TV
with a 4:3 screen. When a 16:9 aspect ratio video is
played back, the video is displayed as shown below.
On 16:9 (wide screen) TV
Original
image size
16:9 Full
4:3
Original
image size
4:3 Pan Scan
16:9
".
*
16:9 Normal
On 4:3 TV
4:3 Letter Box