Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK CONFIGURATION GUIDE DT-324D
•
MPTS channels do not pass through multiplexes and therefore, are
routed directly to the outputs with no restrictions.
•
MPTS Configuration:
In this configuration are caught up to 4 TS that contains MPTS
(Multiple Program Transport Stream) and are extracted directly from
each one of the ASI outputs.
1.1
SPECIFICATIONS
IP INPUT
Type
Connector
TS OUTPUT
Type
Connector
TRANSPORT STREAM
Communication protocol
Transmision methode
Payload
Configuration
Signaling LEDs
ON
PROGRAM
IP:
07/2012
Figure 3.
1 Ethernet Output 100/1000 Mbps.
RJ45.
4xDVB-ASI.
BNC Female, 75 Ohms.
UDP or RTP/UDP.
MULTICAST / IGMP Version 2.
From 1 to 7 packets MPEG-2.
Through the DT-800 Control Module in local
(keypad) or remote mode (PC). See DT-800
specifications.
Green Light:
Off:
Intermittent Light: Module in programming mode.
Asynchronous
intermittent Light:
Off:
Red Light:
Intermittent Light: Ethernet connection established
Module in operation.
Module stopped.
The DT-800 have not received
communication from the module
for more than 60 seconds.
Module in normal mode.
There is not Ethernet connection.
but there is not data traffic to
the module.
Page 3
Publicidad
Tabla de contenido
