Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK CONFIGURATION GUIDE DT-324D
4. DT-324D CONFIGURATION
The configuration menu DT-324D allows you to configure some
parameters that affects the input signal. Menu options for the DT-324D
module are following ones:
-
Ethernet Config.
It allows you to change some module parameters as a host. It
contains
parameters: IP address, mask and gateway. All these fields are
numeric.
-
Config SPTS / MPTS
It allows the user to select between the operating mode SPTS or
MPTS (read introductory chapter for details) independently for each
ASI.
-
TS OUT ASI (1 to 4)
It allows the user to set various parameters of the Transport Stream -
ASI at the module output:
IP Address: It allows the user to assign an IP output to the selected
service.
Port: Destination port used to send ASI output.
Protocol: It allows the user to choose between UDP or RTP protocol
communication.
Enable / Disable: It allows enabling / disabling, in any TS-IP, the IP
address range assignment to a stream by default.
TS ID (only for SPTS): Transport Stream Identifier.
LCN (only for SPTS): Order index for the service in the receiver.
Service Name (only for SPTS): It allows the user to see the name of
the selected service.
-
Firmware Version.
It shows information about the firmware version of the module
microcontroller.
-
Save
It saves all changes made and validated.
07/2012
a sub-menu with some options to define accessing
Page 9
Publicidad
Tabla de contenido
