Temporalidad - FITFIU FITNESS MC-460 Manual Usuario

Lubrication table:
NOTE: Do not over-lubricate. Clean excess lubricant from treadmill. Only use silicone oil.
VOLTAGE ADJUSTMENT
To improve the use of the belt, it can be adjusted if a deviation in direction is noticed after continuous use due to
unconscious leg pressure. To do this, adjust the bolts on the back of the base with the supplied 6mm Allen key as
shown in the picture below.
NOTA: The belt should not be too tight as this can cause noise and possible engine damage.
TENSION ADJUSTMENT
If the tape slips during use, turn off and unplug the equipment. Using the supplied
Allen key, turn the left and right rear roller adjustment screws to the right, then
turn the main power switch back on and operate the equipment at a speed of
6km/h. Run over the treadmill to determine if the treadmill is still slipping. Repeat
this procedure until the treadmill no longer slides.
NOTE: Regularly clean any objects or dust that may fall on the strap.
USO/SEMANA
Less than 3h
From 4h to 7h
More than 8h
In case of left-hand drift, run the belt at 3Km/h and tighten the left-hand screw
clockwise or the right-hand screw counter-clockwise.
In the event of a right-hand shift, run the belt at 3km/h and tighten the right-hand
screw clockwise or the left-hand screw counter-clockwise.

TEMPORALIDAD

Every 5 months
Every 2 months
Every month