Troubleshooting; Storage And Transport - FITFIU FITNESS MC-460 Manual Usuario

TROUBLESHOOTING

The following information may assist in identifying a problem and rectifying it.
Problem
The display shows "E01"
The display shows "E02"
The display shows "E03"
The display shows "E04"
The display shows "E05"
The display shows "E06"

STORAGE AND TRANSPORT

FOLDING AND TRANSPORTING
Unlock the console lock knob and set the vertical column to position 1, release the knob and drop the column to
position 2.
To transport the belt place the belt in vertical position, as shown in the picture, peel off the wheels by pressing in the
direction (A) and when holding itself (B), release your hands.
1
STORAGE
Store equipment in a clean, dry, indoor location. Never leave or use the unit outdoors. Make sure the main power switch
is turned off and the power cord is disconnected from the wall outlet.
Cause
Incorrectly connected signal cable
Broken signal cable
Current overload
Burned engine
Burned PCBs
Input voltage too low
Protection overload
High current surge protection
Burned PCBs
Explosion protection
Burned PCBs
The motor cable is not connected
properly
Problem with the motor cable
2
Solution
Reconnect the signal cable
Change the signal cable
Turn off the machine and restart
Change the engine
Change the new PCB unit
Check the input voltage
Turn off the machine, let it rest and restart.
Turn off the machine and restart
Replace the printed circuit board
Check the input voltage
Change the new printed circuit board
Reconnect the motor cable
Reconnect the motor cable or replace it
A B