Skil SRT1039 Manual Del Propietário página 16

2. Place the router table assembly upside down
on a flat, level surface (Fig. 3b).
3. Push the clamp-handle to the left to open the
router release mechanism (a).
4. Lift up the Tab 1 on the mounting plate to
remove it from the table base (b).
Attaching the Quick-Clamp
Mounting Plate to the SKIL
Routers RT1322-00
(Fixed Base Only) and RT1323-00
WARNING
before installing router into the table,
making adjustments, changing accessories,
removing the router from the table,
performing maintenance, or storing the tool.
Such precautionary safety measures reduce
the risk of unintentional tool operation.
1. Place the router upside down so that it is
resting on its top cap (Fig. 4a)
2. Remove the plastic subbase from your router
by removing the three screws using the
included 5mm combination wrench. Keep the
three screws to be used in the future step 4.
NOTE: If you wish to mount the router with the
subbase, you may need to purchase longer
fasteners. Using the subbase reduces the
range of the cutting depth.
3. If you want to use a vacuum during your
work, this is a convenient time to install the
vacuum adaptor on the router. See your
router manual for the information about the
vacuum adaptor assembly.
4. Align the three mounting plate holes with the
router base holes, also make sure to align the
depth-adjustment rod on the router with the depth-adjustment hole on the mounting plate.
5. Securely mount the quick-clamp mounting plate to your router using the three screws from
Step 2 (Fig. 4b).
6. Always make sure the screws are fully seated on the mounting plate and the router base is
firmly against the mounting plate to ensure secure mounting.
NOTE: The Mounting plate must be mounted with the Tab 2 facing up.
16
Disconnect the router
from the power supply
Fig. 3b
Clamp-
handle
a
b
Tab 1
Fig. 4a
Fig. 4b
Tab 2
Quick-clamp
Mounting Plate
Subbase
Depth-Adjustment
Hole