Skil SRT1039 Manual Del Propietário página 22

Using a Vacuum (Fig . 13)
The vacuum ports molded into the fence
will accept either a 1-1/4 in. or 2-1/2 in.
vacuum hose or adapter. Select the vacuum
accordingly.
NOTICE: Operating the router table without
a vacuum can result in an excessive build-
up of sawdust and wood chips under the
fence assembly and guard and in the cabinet,
reducing the performance of the router table
and fence assembly.
Toolboxes (Fig . 14a and 14b)
Your router table comes with two toolboxes with
hinged doors. The toolboxes are permanently
mounted to the left and right leg assemblies.
Both toolboxes have hinged doors with latching
tabs on the front. Please note the toolboxes
are an integral part of the leg assemblies and
should not be removed.
When not in use, the router bits, insert rings,
feather boards, wrench and starter pin can be
stored in both toolboxes (Fig. 14a). The miter
gauge can be stored at the inner side of either
leg (Fig. 14b).
22
Fig. 13
Fig. 14a
Featherboards and storage areas
Insert rings and
storage areas
Fig. 14b
Bits storage area
Wrench
Starter
pin
a
b