Dynapac F 181 C Instrucciones De Servicio página 133

Código
de fallo y PID(P)
SPN
luz de SID(S)
(S)
adver- FMI
FMI
tencia
515 P091 091
YELLOW 3 3
516 P091 091
YELLOW 4 4
517 S251 1076
YELLOW 12 12
524 P113 113
YELLOW 2 2
527* P154 702
YELLOW 3 3
528 P093 093
YELLOW 2 2
529* S051 703
YELLOW 3 3
551 P091 091
YELLOW 4 4
Causa
High voltage detected at the
coolant level +5 VDC sensor
supply voltage pin 49 of the
engine harness.
Low voltage detected at the
coolant level +5 VDC sensor
supply voltage pin 49 of the
engine harness.
A mechanically stuck fuel control
valve has been detected by the
VP44 fuel pump controller.
Error detected on the High
Speed Governor Droop
selection switch input pin 24 of
the engine harness.
Error detected in the Dual
Output Driver "A" circuit pin 5 of
the OEM harness.
Error detected on the Torque
Curve Selection switch input pin
39 of the OEM harness.
Error detected in the Dual
Output Driver "B" circuit pin 21 of
the engine harness.
Idle validation signals on pins 25
and 26 of the OEM harness
indicate no voltage on either pin.
Efectos
No engine protection for coolant
level.
No engine protection for coolant
level.
Engine may shut down.
Operator can not select alternate
HSG Droop. Normal droop is used.
The device controlled by the Dual
Output Driver "A" signal will not
function properly.
Operator can not select alternate
torque curves. Normal torque curve
is used.
The device controlled by the Dual
Output Driver "B" signal will not
function properly.
Engine will only idle.
D 91