Temperature Selection; Ice Cube Tray; Interior Light - Danby Designer DFF100C1BDD Manual Del Propietário

OPERATING INSTRUCTIONS

TEMPERATURE SELECTION

The refrigerator control panel is located on the back
wall of the refrigerator compartment. Press the plus
and minus button to reach the desired temperature.
The freezer temperature control is located on the
back wall of the freezer compartment. The MAX
position indicates the coldest setting. The MIN
position indicates the warmest setting. The mid point
of the dial should be suffi cient for regular home use.

ICE CUBE TRAY

The appliance is supplied with a fl exible ice cube
tray. Gently twist the tray to remove the ice cubes.
If the ice cube tray is frozen solid, run a little water
over the tray to loosen the ice cubes. Never use
sharp objects to remove the ice cube tray from the
freezer as this can damage the refrigerant lines
inside the freezer.

INTERIOR LIGHT

If the interior light burns out, the LED light strip can
be replaced by following the steps below. Ensure
that the appliance is unplugged before replacing the
light strip.
1. Remove the light cover by pressing upward on
the tab on the bottom and pulling the light cover
downward.
2. Remove the LED light strip by gently pulling it
downward and unplugging it from the port.
3. Plug the new LED light strip into the port and
tuck it into the housing.
4. Replace the light cover by inserting the two tabs
on the top of the light cover into the slots at the
top of the housing and pressing the bottom tab
inward until it clicks into place.
Note: Contact consumer care for information
regarding receiving or purchasing a new LED light
strip based on warranty eligibility.
MIN
1
2
3
4
4
Temperature
Température
MAX