AKG Acoustics SR 40 Modo De Empleo página 12

Table of Contents
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Parts 74, 15, and 90 of the FCC Rules. These limits are designed to provide reasona-
ble protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no gua-
rantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
regulations.
Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
10
FCC Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
1 Safety and Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
1.1 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
1.2 Environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.2 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
2.3 Optional Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
2.4 SR 40 Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
3 Setting Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3.1 Placing the Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3.2 Mounting the Feet on the Receiver . . . . . . . . . . . . . . . . 13
3.3 Rack Mounting a Single Receiver. . . . . . . . . . . . . . . . . . 13
3.4 Rack Mounting Two Receivers Side by Side. . . . . . . . . . 13
3.5 Connecting the Receiver to a Mixer . . . . . . . . . . . . . . . . 14
3.6 Connecting the Receiver to an Amplifier . . . . . . . . . . . . 14
3.7 Connecting the Receiver to Power . . . . . . . . . . . . . . . . . 14
3.8 Before the Soundcheck . . . . . . . . . . . . . . . . . . . . . . . . . 14
4 Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
5 Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
6 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
FCC Statement
Page