Weston Roma 82-0202-W Manual Del Usuario página 6

WARNING! Before cleaning, assembling or disassembling the Tomato Strainer,
make sure it is turned off "O" and disconnected from the power source. Test to make
sure there is no power to the Motor by switching the Motor on "-" and off "O".
1. Hold the Chute with the outlet tilted almost
fully downward and the head ring facing the Motor
(figure 1).
2. Place the head ring of the Chute over the round
raised face on the front of the Motor. Position
the tabs on the head ring next to the slots in the
corresponding tabs extending from the round face
(figure 2).
3. Rotate the Plastic Chute counterclockwise
until the tabs fit into the slots. The Plastic Chute
should now be firmly held in place. When properly
positioned, the outlet of the Chute should dip
slightly downward.
4. Assemble the round end of the Drive Shaft
with a Metal Washer, Spring, Metal Washer,
Plastic Bushing and the Beveled Rubber
Washer. (figure 3).
Rubber Washer has two sides, a flat side and the
beveled side. The beveled side fits onto the top of
the Plastic Bushing like a cap (figure 3b).
Insert the square end of the Drive Shaft into the
5.
corresponding slot in the Auger (figure 4).
Insert the Auger/Drive Shaft Assembly into
6.
the Head.
Position the Screen over the Auger. Line
7.
up the tabs on the Screen with the notches in the
Head. Hold the Screen in place.
8. Slide the Front Ring Nut over the Screen
assembly and turn clockwise to firmly tighten
(make sure the tabs on the Screen remain aligned
with the notches on the Head). DO NOT over-
tighten the Front Ring Nut to avoid damaging the
Motor during operation.
Front
Ring Nut
ASSEMBLY
NOTE:
The Beveled
Screen
-6-
Chute
Motor
Round, raised face on
Chute
Tabs on
Motor
Drive Shaft Assembly
Figure 3b
Plastic
Bushing
Drive Shaft
Assembly
Auger
Head
Figure 1
Ring
the front of Motor
Figure 2
Figure 3
Beveled
Rubber
Figure 4
Washer
Head