NOTE: The Tomato Strainer cannot be used with meat products.
1.
Cut large fruits and vegetables into quarters and small fruits and vegetables in half.
IMPORTANT: Remove pits, stems, hard shells and hard seeds before placing
fruits or vegetables into the Tomato Strainer to avoid damaging the Screen.
Be sure the Power Switch is in the off "O" position. Connect the power cord for the
2.
Tomato Strainer to the power source.
3.
Place the fruits/vegetables in the Hopper. Do not overfill the Hopper. DO NOT
operate the Tomato Strainer without the Hopper in place.
Place a bowl under the Chute to collect juice and pulp. Place a bowl under the
4.
Screen outlet to collect skin and seeds (figure 9).
5.
Turn the Power Switch to the on "-" position.
6.
Feed the fruits/vegetables into the Head. Use the Stomper to push the fruits/
vegetables into the Head. ALWAYS us the Stomper to push food into the Head/
Hopper, NEVER use hands or fingers.
HELPFUL HINTS:
Rerun the skin and seeds through the Tomato Strainer to extract any
A.
leftover pulp & juice. Repeat as necessary.
Use a rubber spatula to scrape pulp from the Screen into the Chute.
B.
When straining is complete, turn the Motor o the off "O" position and disconnect it
7.
from the power source.
INSTRUCTIONS FOR USE
-8-