Bobike one maxi Instrucciones De Uso página 10

03. ASSEMBLY INSTRUCTIONS
EN
FITTING THE CARRIER ON THE BICYCLE
12
The carrier has a center of gravity (F) that must be
positioned in front of the rear wheel axle. If it is positioned
behind the axle, the distance must not exceed 10 cm /
3.94 in. If the gravity centre stays at a higher distance,
place again the rack attachment system (H) at the metallic
support bar (N). Centre and adjust the frame holder (K) at
a height above the rear wheel, so that later, when you add
the weight of the child, the carrier does not touch the
wheel. Note that the frame holder (K) should be
positioned at a maximum of 10 cm / 3.94 in away from the
wheel. These steps are extremely important for child and
cyclist safety. Check the safety of the fasteners regularly.
14
C
Pass the harness to bicycle frame (C) around the bicycle
frame tube. Adjust it as shown in the picture, under
tension. Make sure the unused portion of the belt is not
in contact with the wheel, because it can lock the rear
wheel and cause an accident. This step is extremely
important for a child's safety.
F
10cm
max
13
6Nm
K1
After adjusting the height and positioning of the carrier,
hand tighten the frame holder (K) to ensure that it cannot
move. This tightening is extremely important for the
safety of the child. Make sure that the frame holder (K) is
firmly attached. You need to tighten the 4 bolts (K4)
diagonally, with the same force and in stages - we
recommend a torque of 6 N.m.
15
Make sure you have followed all the prior instructions. If
you have followed them correctly the carrier should look
like the pictures above. When done so, the carrier is ready
for use. IT IS MANDATORY TO READ the chapter on
Caution (06) and Instructions for Use (07) about using
your carrier before using it.
10