Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
03. ASSEMBLY INSTRUCTIONS
EN
FITTING THE CARRIER ON THE BICYCLE
10
N
H6
x4
H1
H
H2
N1
N1
H3
x2
H6
6Nm
x4
H1
6Nm
H6
Once you have applied the rack attachment system (H) properly centered and the metallic clamps (H2) are properly
positioned between limiters of the metallic support (N1), you should tighten the screws (H1) so that when finally tightening,
the rack attachment system is properly centered in relation to the metallic support bar (N). It is very important that the rack
attachment system is centered when applied on the metallic support bar (N).
When you tighten the rack attachment system it could move to the right or left. Note that you should always be placed it at
the center of the metallic support bar (N).
Now, you must tighten the 2 screws (H3), and then the 4 Screws (H1) in cross. You must tighten it with the necessary strength
so the base would be well fixed to the carrier and do not move at all. We recommend a torque of 6 N.m.
8
Publicidad
Tabla de contenido
