Bobike one maxi Instrucciones De Uso página 7

FITTING THE CARRIER ON THE BICYCLE
8
H6
H1
H2
You shall release the metallic clamps (H2). You can use the Allen key no. 5 (H6) provided. Unscrew (relieve only) in diagonal
two opposite screws (H1) in the rack attachment system (H), as shown in the picture. Then do the same for the 2 screws (H3).
The application of protective clamps (H4) is mandatory on the metallic clamps (H2).
9
N
Then put the rack attachment system (H) on the metallic support bar (N). Note that the rack attachment system, when
assembled on the metallic support bar (N), should be centered. Note that when you tighten the rack attachment system it
could move to the right or left. If this happens, center it again. The centering of the rack attachment system (H) against the
metallic support bar (N) is extremely important for the child's safety. The rack attachment system (H) is symmetrical. It´s very
important that you don´t assembly the metallic clamps (H2) over the limiters, indicated on the picture as (N1). The pair of
metallic clamps must be placed between those limiters (N1). This space is indicated on the picture with an arrow. It´s
forbidden to apply the front metallic clamps (H2) outside of this area.
03. ASSEMBLY INSTRUCTIONS
x4
H6
H
H3 x2
N1
7
EN
H2
H4
N1