Altair AL-2163 Manual De Instrucciones página 5

ASSEMBLY AND INSTALLATION:
INSTALLATION (Fig. 2)
6. Unscrew the lock nuts from the mounting bracket.
7. Pull the power supply wires out from the outlet box, and attach the mounting bracket
to the outlet box, using the bracket mounting screws.
Strip approximately ¼" of insulation from each supply wire from the outlet box. Raise
8.
the main fixture body to the wall, bringing the wall plate close to the outlet box.
Make the following wire connections using the wire nuts:
White (neutral) supply wire
Black (hot) supply wire
Supply ground wire
Wrap each wire connection with 5 cm / 2 in of electrical tape.
9. Place the wall plate over the outlet box, making sure the fixture mounting screws
feed through the holes on the wall plate. Adjust the fixture mounting screws until
they protrude out from the wall plate ¼". Remove the wall plate and secure the
position of the fixture mounting screws by tightening the hex nuts against the
mounting bracket.
10. Carefully tuck all WIRES and wire nuts into the outlet box. Place the wall plate back
onto the fixture mounting screws, and secure it into place using the lock nuts.
11. After installing the fixture, caulk the upper 2/3s of the wall plate to the mounting
surface. Leave the bottom 1/3 un-caulked to allow for drainage of any water that might
leak into the enclosure. The manufacturer recommends a non-drying exterior caulking
material. A good example is a clear silicone rubber sealant for exterior use.
12. RESTORE POWER AT THE CIRCUIT BREAKER. Turn on the wall switch.
Lock
Nut
Wall
Plate
Mounting
Screw
Hex
Nut
White
Fixture Wire
Fixture
Ground
Wire
to White fixture wire
to Black fixture wire
to Fixture ground wire
Mounting
Bracket
Fixture
screw
Wire
Nut
Supply
Ground
Black
Wire
Fixture
Wire
5
Outlet
Box
Black (Hot)
Supply Wire
White (neutral)
Supply Wire
Fig. 2