RHOSS Brio-I SLIM Instrucciones De Uso página 24

INSTALLATION
2.6 Horizontal or ceiling installation (MVP+KVXO, IXP)
Using the paper template, trace on the ceiling the position
of the two fixing brackets and the two rear screws. Using a
suitable drill, make the holes and insert the toggle bolts (2
for each bracket); fix the two brackets. Do not over-tighten
the screws. Position the machine on the two brackets,
keeping it in position and then fix the two screws into the
rear toggle bolts, one on each side.
Make sure that there is sufficient inclination of the unit
towards the drainage pipe to facilitate the water drainage.
Fully tighten all 6 fixing screws.
toggle bolts
A
brackets
B
1÷2°
24
A B A
D
For installation of the MVP versions, horizontal condensation
collection basin accessory kits are available KVXO.
The installation of MVR, IVR units in horizontal position is
prohibited.
Carefully check the inclination of the exhaust pipe.
Any counterslope of the discharge line can cause
water leakage
screws
C
drainage pipe
D
B
C
U I S