Publicidad
Idiomas disponibles
Idiomas disponibles
4
Scope of supply
1x ignition cover protection holder
1x aluminum protector
2x countersunk screw M5x10
4x collar screw M6x40
4x spacer
This product has not been homologated and therefore does
not have offi cial approval for use on public highways. The
customer must check with the national regulatory authorities to
establish whether individual type approval or a full homologa-
tion of the particular vehicle with the ignition cover protection
installed is guaranteed in the planned country of use.
Preparatory work
- Remove the front spoiler (see the user manual).
Preassembly
- Position protector
on holder
- Mount and tighten screws
- Position spacers
.
Assembly
- Lay vehicle on its side.
- Remove screws
.
- Release the remaining screws of the ignition cover.
Place a suitable container under the engine. Engine oil may
escape!
- Position preassembled ignition cover protection.
- Mount screws
(included) but do not tighten them yet.
- Tighten all screws on the ignition cover in a crisscross pattern to
12 Nm.
Final steps
- Install the front spoiler (see the user manual).
- Check engine oil level, add if necessary.
(all included).
(included).
Publicidad
