Draining Away The Waste Water; Electrical Connection - Brandt AX545FXE1 Instalación Y Consejos

Installing your dishwasher

Draining away the waste water

Length of the drain hose: standard
1.50m. If necessary, you can increase
the length of the drain hose (4m
max.). In this case, check that the
machine drains correctly.
Connect the drain hose:
- To a ventilated siphon
- To a sink U-bend
Remove the stopper form the U-
bend.
Remove the rubber stopper and, if
necessary, add a collar.
- Directly to your sink
Ensure that you hold your drain hose
in place with the end connector to
avoid flooding.
22
For machines installed in columns, the
height of the drain hose must not be
higher than the top of the machine.
NB: Pull the pipe
gradually
when installing it
to avoid kinking it.

Electrical connection

Mains voltage: 220-240V
Fuse: 10A, 13A or 16A
The socket outlet must
grounded to Earth.
In all cases, the connection must
comply with the standards in force in
the country concerned, together with
the supplementary regulations of the
Electricity Authority. The machine
must be switched off when the
connection is made to the electrical
circuit.
We cannot be held
liable for any damage caused
by the faulty earthing of the
machine.
If you have any doubts regarding the
condition of your installation, do not
hesitate to have it checked by a
qualified electrician.
The machine must be installed so that
the socket remains accessible.
GB
Installing your dishwasher
Do not use an electrical extension, a
double socket or an electrical timer.
The installation must comply with the
country's prevailing norms.
Your dishwasher complies with
European Directives 73/23/EEC (Low
Voltage Directive) and 89/336/EEC
be
(Electromagnetic Compatibility),
modified by Directive 93/68/EEC.
IMPORTANT for the dishwasher without plug.
The wires in this mains lead ar coloured in accordance the following
code :
Green & Yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the terminal in your plug, proceed as follows ; The wire
which is coloured Green and Yellow must be connected to the terminal which
is marked with the letter «E» or by the earth symbol
end Yellow.
The wire which is coloured Blue must be connected to the terminal which is
marked with the letter «N» or coloured Black.
The wire which is coloured Brown must be connected to the terminal which is
marked with the letter «L» or coloured Red.
Replacing
power cable
For your safety, this operation
must be performed by the
manufacturer's After-Sales
department or a person with
similar training and experience
in order to avoid any risk.
or coloured Green
GB
the
23