Usb - Yamaha BRX-610 Manual De Instrucciones

Problem
No sound. The iPod is not connected correctly.
The iPod sounds, but
you cannot operate it
with this unit or the
remote control.
No sound of your No sound of your iPod can be output
iPod from the TV. from this unit to the TV through the
HDMI cable.
This unit cannot be
The iPod is not supported by this unit.
operated by the
remote control.
The iPod is not connected correctly.
The iPod software version is out of date.
You cannot operate The iPod is not connected correctly.
from the iPod.
The playback The iPod you set is not compatible with
information is not the playback information display.
displayed on the
front panel display.
The iPod does not The iPod is not connected correctly.
charge up.
The iPod is not supported by this unit.

USB

Note
In case of a transmission error without a status message appearing on the front panel of this unit, check the connection to the USB
device (refer to page 15).
Status message
USB ERROR
Problem
The file in the USB The USB device is not recognized.
device does not play.
Incorrect USB device connections.
The file format is not compatible with
this unit.
If the solutions above do not resolve the
problem, the USB device is not playable
on this unit.
Cause
Cause
The connected USB device is not
playable on this unit.
The USB device is connected at an
angle.
Cause
Remedy
Connect the iPod and this unit by a USB cable
correctly.
Use the speakers of this unit.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS and iPhone 4
are supported.
Connect the iPod and this unit by a USB cable
correctly.
Update the iPod software version to the latest. If the
problem cannot be solved, even with the latest
software, reset the iPod.
Connect the iPod and this unit by a USB cable
correctly.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS and iPhone 4
are supported.
Connect the iPod and this unit by a USB cable
correctly.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS and iPhone 4
are supported.
Remedy
Disconnect the USB device. Change input source
other than USB and select USB as input source
again. Then connect playable USB device again.
Remedy
Connect the USB device again.
Connect an AC adapter if supplied with the device.
Connect the USB device again.
Replace the file with a correctly recorded file
playable with this unit.
Try another USB device.
TROUBLESHOOTING
Page
12
—
12
12
—
12
12
12
12
Page
15
Page
15
—
15
3
—
45
En