SSS Siedle BCMC 650-02 Informacion De Producto página 6

English
Application
Camera 80 for Siedle Vario.
Available for the systems In-Home
bus, Access or as a system-free
camera.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
1 In the case of video systems, the
following mounting situation must
be avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Scope of supply
• Camera module 80
• Terminal block
• Allen key size 2.5
• This product information
Mounting
2 Recommended mounting height
appr. 1.60 m to centre camera.
3 Note the mounting position of the
camera, the type designation must
be legible at the top back of the
module.
4 Pick-up angle of the camera
with an angle of aperture of 80°.
The angle of vision of the camera
module can be pre-adjusted hori-
zontally and vertically by around 30°
depending on the mounting situ-
ation.
6
5 On the back of the camera,
release the centrally positioned
screw by screwing the Allen key one
turn to the left. Position the camera
eye using the Allen key to the
required viewing direction.
6 Fix the camera eye in the required
position by turning the screw. Do
not fasten the screw too tightly.
Terminal assignment
BCMC 650-...
TaK In-Home bus
TbK camera branch
Ta In-Home bus
Tb
Vc Camera actuation
GND
b Power supply 12 V AC
c
ACM 670-...
V1 video signal
V2 (two-wire FBAS)
V3 Camera supply
V4
V5 Actuation of
V6 video output
CMC 612-...
+M Supply voltage
-M 20–30 V DC
Vc Camera actuation
-
VKA Actuation of
camera distributor
A1 Potential-free contact
A1
b Power supply 12 V AC
c
coaxial connection
L/S L = lead, S = shield
Pilfer safeguard
In order to protect the Vario modules
from unauthorized access, the pilfer
safeguard controller DSC 602-... can
be optionally used in conjunction
with the ZDS 601-... This can be
used to protect the inserted modules
from unauthorized access.
Installation
Installation, commissioning and pro-
gramming are described in the rel-
evant system manual and enclosed
with the line rectifier/server.
Servicing
If a camera has to be exchanged,
this is unplugged at the terminal
block and replaced.
7 Exchange of an existing camera
module (CMC 611-...) for a
CMC 612-... The installation only
needs to be performed at the door
station. The terminals "–" and Vcs
must be bridged to terminals "–"
and Vcs at the TLM 612-...