Assembly On The Stand Extension - Nogueira DPM-1 Manual De Instrucciones

Assembly on the stand extension

The option for installation of the DPM on the stand
extension, makes it possible to place the motor on
the respective stand, and then there is no need to
use a base.
BASIC INSTALLATION SEQUENCE
The stand extension version is shipped from the
factory preassembled. It is just necessary to install
the motor and the belts. The following describes
the correct assembly sequence:
1- If your DPM model is equipped with a cyclone,
first it is necessary to remove the ventilator box, as
shown in the following figures. If the machine is not
equipped with a cyclone, skip this step and go
below to step 2.
Remove the 3 screws (A) fastening the box to the machine.
Remove the 11 screws (B) fastening the two halves of the
ventilator box.
2- Open the shielding and install the motor and the belts, as the following instructions show:
Remove the screws (F) fastening the shield
cover over the belts.
14
Instructions Manual
Remove the box (C), the ventilator
(D) and the cover from the box (E).
Remove the shield cover.