Practical Guide - Nogueira DPM-1 Manual De Instrucciones

Practical guide

Machine is jammed
Low production
Uneven product cutting
It is difficult to grind dry
products
It is difficult to start the
actuation
Due excessive intake, the
motor cannot maintain the
required rotation and the
product accumulates inside
the machine
Not enough intake to the
machine
Machine rotation is below
recommended
The product is damp
The machine adjustment is
incompatible with the
product being processed
The blade cutting edge is
not sharp
The counter-blade is worn
or not well adjusted
The hammers are worn or
damaged
Hammers are stuck
Excessive product inside
the machine
DPM-500/1/2/4
Stop the motor, clean the excess
product, start operating again but
ow control the intake to the
machine, so that it does not exceed
the recommended capacity
The intake must be continual, but
not excessive, which can cause
jamming
If the rotation of the machine is
below the recommended, the
hammers will take too long to shred
the product and due to this, the
production will drop. Therefore, it is
necessary to maintain the
recommended rotation of the
machine
If the products are very damp, the
holes in the sieve can become
blocked. Therefore, shredding must
be done only on dry products
It is necessary to check if the sieve
being used is compatible with the
desired final product
Sharpen the blades again as
recommended in the item on
Sharpening blades
Proceed as recommended in the
item on Counter-blade adjustment
Change the sides of the hammers
or change or new ones, proceed as
recommended in the item on
Changing hammers
Wash the chutes, blades and
hammers, using water after
chopping fresh products, especially
when not used for extended
periods of time
Operate the machine until all the
product comes out
27