Power Switch - Peavey MAX Serie Manual De Instrucciones

(13) TUNE/MUTE (not available on Max 208)
Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED screen will indicate which note
is being played while the red and green LEDs above the screen indicate whether the note is flat (red), sharp (red) or in tune (green).
This switch also mutes the DI.

(14) POWER SWITCH

Rear Panel
(15) AC POWER INLET:
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to provide
power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable
grounding adapter should be used, and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always
make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal that is marked by
the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire that is colored blue must be connected to the
terminal that is marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the terminal that
is marked with the letter L, or the color red.
(16) LINE VOLTAGE SELECT SWITCH
This selector switch allows the amplifier to be operated at different line voltages. Please be sure this switch is set to the
proper voltage for your area before connecting the amplifier to a power source or turning the amplifier on for the first time.
NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE AMPLIFIER IS TURNED ON.
(17) SPEAKER OUTPUT JACK (Max 150, 250, and 300 only)
This combination 1/4" / twist-lock connector is used to connect a speaker cable to the amplifier. The minimum load impedance on the
amplifier is 8Ω.
(18) FOOTSWITCH JACK
The optional footswitch (part number 03022910) plugs into this jack. The footswitch controls OVERDRIVE and MUTE.
(19) HEADPHONE OUTPUT
1/8" headphone output for personal monitoring.
(20) AUX INPUT
This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX® Series bass amp and play along
16
15
22
20
17
23
21
19
18