Before First Use - Moulinex LM 2311 Manual De Instrucciones

• Do not use your appliance if it does not operate correctly, if it has been damaged or if the power
cord or plug is damaged. To maintain safety, these parts must be replaced by an Approved
Service Centre.
• Any intervention other than normal cleaning and maintenance by the customer must be
performed by an Approved Service Centre.
• For you own safety, only use accessories and spare parts from the appliance manufacturer,
which are especially designed for your appliance.
Safety locking
The appliance will not operate if the blender jug assembly (D) or the accessories (E) or
(F) are not correctly positioned and locked on the motor unit (A).
Before using your appliance for the first time, clean all the accessories (D, E, F) in warm
water and washing up liquid, except for the motor unit (A).
CAUTION: The blades are extremely sharp; handle them with caution when using
or cleaning the appliance and when emptying the bowls or jug.
Make sure all the packaging has been removed before operating the appliance.
Important note: Turn the speed selector (B) to "0" before placing the blender assembly
or accessories on the motor unit.
Do not turn the blender on if the lid (D6) is not properly in place on the blender jug
(D4).
Use
Using the blender
• Before assembling the jug (D) choose the most convenient position for the jug handle (D4)
(on the right or on the left.).
With the "clic" button (D2) of the blades block (D1) in front of you, place the locating rib
(D3) in the assembly slot located at the base of the jug (D4) (fig. 1 a) then lower the blade
unit (D1) down into the second slot (D4) (fig. 1b) located at the front of the jug base until
the unit is locked in place (you will hear a click) (fig. 1c).
Make sure that the jug (D4) and the blade unit (D1) are well assembled, press the button
(D2) and place the ingredients in the jug without exceeding the maximum level indicated
on it:
* 1.5L for thick mixture
* 1.25 L for liquid mixtures
Make sure that the joint (D5) is on the lid (D6) (fig. 2 a) and place the two together on the
jug (D4).
Put the cap (D7) in the slot destined for it on the lid top.
Place the assembled blender jug (D) on the motor unit (A), with the "clic" button (D2) on the
blade unit aligned with the "clic" button (C) on the motor unit (Fig. 2b) and press the jug
down firmly to lock it on the motor unit (you will hear a double click) (Fig 3).
Plug in the appliance and turn the speed selector (B) to the desired position or press "Pulse"
a few times.
9

Before first use