Troubleshooting - Silvercrest SEM 1100 B3 Instrucciones De Uso

19) Push in the "Steam" button
20) Hold a container under the milk frother 0 and slowly turn the steam control
button 7 to the position " + " as soon as the green heating-up control lamp 5
lights up.
21) After about 1 minute, close the steam control 7 (turn it in the direction of the
" - " as far as the stop), press the "Steam" button
the appliance.
NOTE
► If no button is pressed, the appliance turns off automatically after
30 minutes.

Troubleshooting

Malfunction
The espresso no longer
flows out.
The espresso drips over
the edges of the sieve
holder u, not from the
openings.
The espresso is cold.
The pump is unusually
noisy.
■ 44 │ GB │ IE
4 so that it clicks into place.
Cause
• The espresso powder is too
moist and/or compressed
too tightly.
• No water in the water tank 9.
• The holes of the sieve holder
openings are blocked.
• The sieve holder u is not
correctly inserted.
• The sieve holder openings are
blocked.
• There are espresso powder
residues on the edges of the
sieve holder u.
• The appliance was not
preheated.
• The green heating-up control
lamp 5 has not yet glowed.
• The cups were not pre-warmed. • Pre-warm the cups.
• The water tank 9 is empty.
4 again and switch off
Solution
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder.
• Fill the water tank 9
with water.
• Clean the sieve holder u.
• Insert the sieve holder u
correctly.
• Clean the sieve holder u.
• Clean the espresso
powder residues from
the edges of the sieve
holder u.
• Preheat the appliance.
• Wait until the green
heating-up control
lamp 5 lights up.
• Fill the water tank 9
with water.
SEM 1100 B3