INSTRUCTIONS FOR USE
BEFORE USE:
Unpack the appliance.
Check that the power supply parameters of the appliance correspond to the parameters of the local
mains.
Before operating the appliance for the first time, clean it and its accessories as described in section Main-
tenance and Cleaning of this instruction manual.
Before assembling the appliance, make sure that the mixer is disconnected from the mains, and the
speed controller is set to "0".
Attention!
During the initial period of use the mixer may give off an unpleasant odour. This smell will fade after a
fairly long period of use.
OPERATION
Make sure that the appliance is disconnected from the power source.
Put ingredients into a bowl (included depending on the model).
Select the desired attachments and insert them into the mixer sockets.
Attention!
Insert suitable attachments into the mixer' s sockets. One set of attachments is suitable for kneading
dough and the other is used for beating eggs or similar products.
Attention! Do not put any forks, knives or spoons into the bowl during mixer operation.
The maximum continuous operation time must not exceed 5 minutes. If you need to use the mixer for
a longer time, wait until the appliance cools down to room temperature (which takes about 30 minutes)
after every 5 minutes of continuous use. For best results when mixing batter for yeast-raised cakes, we
recommend that you start mixing at a low speed, then increase it to the maximum speed at the end of
the process.
After you have finished using the appliance, set the speed controller to "0" and disconnect the appliance
from the mains.
If residue from mixed products needs to be scraped off a beater or an agitator, use a wooden spatula.
While holding the attachment with one hand, press the "EJECT" button with the other hand.
Remove the attachments from the sockets.
Do not operate the appliance with more than 810g flour.
Using the base and auto rotating bowl (accessories included depending on model)
Press the unlock appliance arm button to lift base arm.
Hold the appliance by hand while pressing the main unit anchoring button to remove it.
Fix the accessory as desired on the anchor by matching the hole and ensuring it is properly engaged.
Place the main unit body in the bowl stand and press down until the button returned to is original position.
Press the unlock appliance arm button to return to initial position.
13