Plasmacluster Ion Generating Unit - Sharp UA-KIL80E Manual De Operación

9. Pull down the Shaft (lower) and
attach it to the Back Panel.
2
Shaft (lower)
10. Install the Pre-Filter Lock.
1
1
2
2
11. Install the Dust Box and the Back
Panel.
1
PLASMACLUSTER ION
GENERATING UNIT
( Electrode Section )
1. Remove the Unit Cover, and pull out
the Unit Holder.
2. Remove dusts from the Electrode
Section.
Unit Cleaning Brush
Electrode
Before
cleaning
Around the base
3. Insert the Unit Holder in the product,
and install the Unit Cover.
NOTE
• Do not clean with anything other than the Unit
Cleaning Brush. Doing so could lead to failures in
the Unit.
• A bent electrode could be cut off and dropped
during the cleaning process, but it will not change
the performance.
• Do not touch the electrode directly. Doing so could
lead to pain / itching.
• Do not transform the Electrode Section. Doing so
can damage it.
• Do not touch the Connection Terminals. Doing so
can damage them.
EN-19
Unit Cleaning
Brush
After cleaning
Electrode
Click
Connection Terminals