Connecting Receivers - Shure UA845 Guia Del Usuario

CONNECTING RECEIVERS

SINGLE UA845 SETUP
1. Using low-loss, 50 W coaxial cables (RG-58 or equivalent), connect the
right and left (Channels 1 through 4, A and B) RF OUTPUT ports on the
UA845 to the corresponding left and right antenna inputs on each
receiver. Use the CASCADE ports to connect a fifth receiver.
2. Using the supplied power cable, connect the UA845 to a power outlet.
3. To daisy-chain UR4 Receivers together with Power OUTPUT cables, con-
nect the Power OUTPUT connector of the UA845 to the Power INPUT
12 VDC POWER CONNECTOR
ANT B IN
AC PWR OUTPUT
AC PWR INPUT
TO POWER SUPPLY
AC PWR OUTPUT
AC PWR INPUT
12 VDC PWR INPUT
ANT A IN
connector of one receiver. Connect the remaining receivers similarly.
Connect the POWER INPUT of the unit to a power supply.
NOTE: No more than five (5) Shure UHF receivers should be powered
through a daisy-chain from a single UA845.
4. To power Shure UC4 receivers, connect the power input ports of the UC4
receivers to the 12 Vdc OUT of the UA845. Up to four UC4 Receivers
can be powered.
UA845
CASCADE B CASCADE A
ANT B OUTS
ANT B IN
UR4 RECEIVER
UR4 RECEIVER
UR4 RECEIVER
UC4 RECEIVER
ANT B IN ANT A IN
SINGLE UA845 SETUP
FIGURE 8
11
12 VDC POWER CONNECTOR
ANT A IN
ANT A OUTS
ANT A IN
UC4 RECEIVER
ANT B IN
ENGLISH