Easy Home MD 10229 Manual Del Usuario página 15

Operation
− The castors must be attached before use.
− Do not use water with any chemical additives added. The
water must be cold or lukewarm. Do not use hot water
above 104 °F (40 °C).
− Do not fill water above the MAX line on the front of the
water tank.
− Use only clean water for filling the ice blocks. Do not fill
water above the maximum marking.
1. Remove the plastic strap of the remote control
Fig. C).
2. Turn the water tank lock
unlock, and take out the water tank
3. To remove the water tank completely, first remove the pump from the
bottom of the water tank by pressing the two end tabs together and pulling
it upwards (see Fig. F).
4. Fill clean, cold water into the water tank, taking care not to overfill above
the MAX line.
5. To replace the water tank, first insert the pump into its slot on the bottom of
the water tank by pressing the two end tabs together.
Carefully push the water tank into its position, and turn the water tank lock
clockwise to the vertical position to lock.
6. Connect the power plug to a suitable electrical outlet.
Once the product is under current it emits a beep sound and switches to
standby mode.
The power indicator light
7. You may now use the buttons on the control panel
the remote control to operate the product (see chapter "Control Panel").
8. When done using the product, press the On/Off button
standby mode.
9. Unplug the power plug.
The two ice blocks
desired.
1. Open the cap, add clean water up to the maximum level
2. Once frozen, the ice blocks can be added to the water tank.
16
14 counter-clockwise to the horizontal position to
15
marking, close and place in your freezer for a few hours.
Make sure that the water level in the water tank does not go
above the MAX level indicated.
5 (see Fig. E).
turns on.
can be used for extra cooling effect, if
3
10 before first use (see
1 or the buttons on
6 to switch to