General Safety Instructions; Safety Instructions Related To The Product And Technology - Aventics PROFINET IO Manual Del Usuario

68 AVENTICS | Bus Coupler AES/Valve Driver AV, PROFINET IO | R412018140–BAL–001–AG
Notes on Safety
2.5

General safety instructions

Observe the regulations for accident prevention and environmental protection.
Observe the national regulations for explosive areas.
Observe the safety instructions and regulations of the country in which the product is used or
operated.
Only use AVENTICS products that are in perfect working order.
Follow all the instructions on the product.
Persons who assemble, operate, disassemble, or maintain AVENTICS products must not
consume any alcohol, drugs, or pharmaceuticals that may affect their ability to respond.
To avoid injuries due to unsuitable spare parts, only use accessories and spare parts approved
by the manufacturer.
Comply with the technical data and ambient conditions listed in the product documentation.
You may only commission the product if you have determined that the end product (such as
a machine or system) in which the AVENTICS products are installed meets the country-specific
provisions, safety regulations, and standards for the specific application.
2.6

Safety instructions related to the product and technology

Danger of explosion if incorrect devices are used!
There is a danger of explosion if valve systems without ATEX identification are used in an
explosive atmosphere.
When working in explosive atmospheres, only use valve systems with an ATEX identification
on the rating plate.
Danger of explosion due to disconnection of electrical connections in an explosive atmosphere!
Disconnecting the electrical connections under voltage leads to extreme differences in electrical
potential.
Never disconnect electrical connections in an explosive atmosphere.
Only work on the valve system in non-explosive atmospheres.
Danger of explosion caused by defective valve system in an explosive atmosphere!
Malfunctions may occur after the configuration or conversion of the valve system.
After configuring or converting a system, always perform a function test in a non-explosive
atmosphere before recommissioning.
Risk of uncontrolled movements when switching on the system!
There is a danger of personal injury if the system is in an undefined state.
Put the system in a safe state before switching it on.
Make sure that no personnel are within the hazardous zone when the valve system
is switched on.
Danger of burns caused by hot surfaces!
Touching the surfaces of the unit and adjacent components during operation could cause burns.
Let the relevant system component cool down before working on the unit.
Do not touch the relevant system component during operation.
DANGER
CAUTION