Allmand MAXI-POWER MP15XR Manual Del Operario página 10

WARNING
Unsafe Operation Hazard
• Failure of trailer lights to operate properly could result
in death or serious injury. Always check for proper
operation of trailer lights, and repair or replace as
needed.
6
7. Retract the tongue jack. See Transporting - Using The
Tongue Jack.
8. Remove the wheel chocks.
The trailer is now ready for towing.
To disconnect the trailer from the tow vehicle
1. Chock the wheels.
2. Deploy the tongue jack. See Transporting - Using The
Tongue Jack.
3. Disconnect the trailer lighting cable from the tow vehicle
lighting cable.
4. Remove the safety chains from the safety chain pockets
on the tow vehicle.
5. Uncouple the trailer hitch from the tow vehicle hitch. See
Transporting - Coupling And Uncoupling The Trailer
Hitch.
6. Move the tow vehicle away from the unit.
10
Using The Tongue Jack
The unit is equipped with a tongue jack to raise and lower the
trailer tongue, and to level the trailer front-to-rear.
To deploy the tongue jack
1. Remove the jack locking pin (A, Figure 7).
2. Rotate the tongue jack 90° into the operating position (B,
Figure 7). Install the jack locking pin (C).
WARNING
Unsafe Operation Hazard
• Failure to install the jack locking pin could result in
death or serious injury. Be sure the tongue jack is
locked in the operating position with the jack locking
pin.
3. Unfold the jack handle into the operating position (D,
Figure 7).
To lower the jack foot (raise the trailer tongue)
• Turn the jack handle counterclockwise (E, Figure 7) to
lower the jack foot (F) and raise the trailer tongue.
To raise the jack foot (lower the trailer tongue)
• Turn the jack handle clockwise (G, Figure 7) to raise the
jack foot (H) and lower the trailer tongue.
To retract the tongue jack
1. Be sure the trailer is securely supported by the tow
vehicle or other approved means.
WARNING
Unsafe Operation Hazard
• Failure to support the trailer tongue before retracting
the tongue jack could result in death or serious injury.
Be sure the trailer tongue is securely supported before
retracting the tongue jack.
2. Fully raise the jack foot.
3. Fold the jack handle into the transport position (I, Figure
7).
4. Remove the jack locking pin (J, Figure 7).
5. Rotate the tongue jack 90° into the transport position (K,
7). Install the jack locking pin (L).