Echo SRM-260 Instrucciones Para La Instalación página 2

2
I
nstALLAtIon
1. Close choke and remove air filter and cover.
2. Disconnect ignition stop leads (A) and (B).
3. Loosen nut (C) and remove throttle linkage from carburetor
bracket.
4. Remove inner throttle cable from carburetor swivel (D).
5. Loosen clamping bolt (E) and pull drive shaft assembly from
clutch case.
6. Loosen two (2) rear handle screws (F) and pull rear handle from
the drive shaft assembly.
7. Loosen four (4) screws (G) and remove front handle.
8. Insert square nut (H) in lower handle bracket (I) and place bracket
on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
9. Secure with lower handle bracket clamp (J) and three (3) 5mm x
30mm hex socket bolts.
10. Position harness clamp (M) 220 mm (8-5/8 in.) from engine
end of drive shaft assembly. Install 5x18 mm bolt, but DO NOT
tighten at this time.
INSTALLATION INSTRUCTIONS U-HANDLE KIT
G
H
I
J
400 mm
(15-3/4 in.)
M
220 mm
I
J
(8-5/8 in.)
D
C
B
A
E
F
ENGINE
END