Electrical Requirements; Important - Emerson RIPTIDE CF605BQ00 Manual Del Usuario

1. Unpacking Instructions
THIS FAN MODEL IS SUITABLE FOR WET LOCATIONS
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips Head Screwdriver
One Wire Stripper
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
IMPORTANT: Your ceiling fan will not function
properly, and may be damaged, if used with
any wall dimmer switch or control other than
the Emerson Electric Fan/Light Remote Control
supplied with the fan.
Your new Ceiling Fan will require a Grounded Electrical
Supply Line of 120 Volts AC, 60 Hz, 15 Amp Circuit.
The Outlet Box MUST be securely Anchored and
capable of withstanding a Load of at least 50 Pounds.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less", and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
SUCH AS PORCHES, PATIOS, AND DECKS.
One Stepladder
One Wire Cutter
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
Your Emerson Ceiling Fan comes supplied with a Fan/
Light Remote Control which consists of a Receiver
mounted inside the Ceiling Cover of the Fan Motor
Housing. This system allows you to regulate your
Ceiling Fan Speed and Light ON/OFF.
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 17).
If you feel you do not have enough wiring knowledge
or experience, have your fan installed by a licensed
electrician.
If your Fan is to replace an Existing Ceiling Light
Fixture, turn Electricity OFF at the Main Fuse Box at this
time and remove the Existing Light Fixture.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
!
To avoid fire or shock, follow all wiring instructions
carefully.
A n y e l e c t r i c a l w o r k n o t d e s c r i b e d i n t h e s e
instructions should be done or approved by a licensed
electrician.
Please Call Technical Support at 1-800-654-3545
if you have any questions about installation and
operation of this Ceiling Fan.
4
WARNING
WARNING
WARNING
U.L. Model No.: CF605