Publicidad
Step 4
Flip the ENDS (A and B) over. Turn six BLACK 9/16" FLAT HEAD
å
SCREWS (32S) into the ENDS (A and B) until the shoulders of
the SCREWS rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Now, slide the END MOLDINGS (P) onto the ENDS (A and B). To
å
do this, line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS. Using your hands, apply pressure on
the MOLDINGS as you guide the MOLDINGS onto the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS, remove
å
them and slide them on again.
These edges
should be even.
Page 8
A
P
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
B
Shoulder
32S
418658
These edges
should be even.
P
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/services
Publicidad
