Technical Data - Davin DV‑101A Manual

1.0 GENERAL
The DV-101A is a multifunctional analogue seconds time clock.

1.1 TEchNIcAL DATA

Dimensions
Required voltage
Max. Output
Isolation level
1.2 REquIRED (AcTIvE) vOLTAGE Dv-101A
The DV-101A must be connected to the mains voltage via a grounded socket near the water barrel.
The DV-101A has a 6 Amp thermal fuse.
This fuse turns off the DV-101A on automatically in case of overload and / or short-circuits. (also see
1.8)
1.3 INSTALLATION Of ThE Dv-101A
Remove the front panel of the DV-101A housing.
At the bottom of the housing you will 4 fixing holes, which you can use to insert a screw.
You can mount the housing onto a (flat) surface with the 4 screws.
1.4 cONNEcTING A PuMP TO ThE Dv-101A
You can connect a random pump to the DV-101A.
However, in this case the nominal power of the pump should not be higher than 5 Amp.
1.5 SETTING ThE Dv-101A.
The time relay is multifunctional,
This means that there are many different switch modes to choose from, the so called' DIP-switches'.
These are located under the black switch of the time relay. (Next to the time clock, on the right)
STANDARD (factory settings)
The standard setting of the time relay is 60 sec. 'DIP-switch' mode =
This means that the time setting on the time relay matches the displayed number in seconds.
(If you wish to water for 30 sec. you can turn the time relay to 30)
'DIP-switch' 4 is ALWAYS on:
10
DV-101A Binnenwerk PMS.indd 8
Manual DV‑101A
: 210 x 140 x 110mm.
: 230 Vac / 50Hz.
: 5 Amperes.
: IP-44
23-3-2012 2:43:11