Leggett & Platt 190-0045 Guía De Preparación página 3

REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
STEP 1
Plug base into power outlet.
STEP 2
Simultaneously press and hold both the HEAD DOWN and
FOOT UP buttons on the remote control (FIGURE 1). While
holding these buttons, press and hold the LEARN button
on the control box (FIGURE 2) or the PAIR button on the
in-line switch (FIGURE 3), as equipped. Hold until you
hear an audible sound, then release all buttons.
FIGURE 1
UBL
H
E
A
D
HEAD DOWN
SET
HEAD
FIGURE 2
FLAT
FOOT UP
F
O
O
PILLOW
T
ZG
SNORE
TIMER
WAVE
LEARN
BUTTON
CONTROL
BOX
UBL FLAT
H F
E O
A PILLOW O
D T
SET ZG SNORE
TIMER
HEAD
WAVE
FIGURE 3
ELECTRICAL
POWER CORD
Note: Your base may be equipped with an in-line switch
(pair button) as part of the electrical power cord located
near the end of the power cord. This can be used in lieu
of the learn button on the control box.
STEP 3
Operate the remote control to verify the base functions
correctly.
IN-LINE
SWITCH
PAIR
BUTTON
3