Charging Process; Battery - Wayscral EVERYWAY E-CARRIER Manual Del Usuario

•
The external flexible cable of this product cannot be replaced;
if the cord is damaged, the product should be discarded.
•
At the end of its life, take the bike to a recycling centre.

5. Charging process

If a power outlet is available near your bicycle, you can charge the
battery directly on the bicycle without detaching it. The charger port is
covered by a plastic cap, simply open it to charge the battery directly.
Removing the battery can be useful in places that cannot
accommodate your bike or when it is not near a power outlet.
RECOMMENDATION: the battery should be charged
indoors in a ventilated area.
Please charge the bicycle battery according to the following procedure:
•
The battery can be charged using a standard power outlet. You
do not need to activate its switch.
•
Insert the charger plug into the battery and plug the charger
power cable into a nearby socket.
•
When charging, the LED on the charger will be red to show that
it is working correctly. When it turns green, it means that the
battery is charged.
•
To finish the charging, you must disconnect the power plug and
then the plug connected to the battery. Finally close the cap of
the battery socket.
III.

Battery

This power-assisted bicycle is fitted with a high quality Li-ion battery.
Li-ion batteries do not have a charge memory and have a wide
temperature tolerance ranging from -10 to 40°C.
To ensure maximum battery life and protect it from damage, please
follow the use and care instructions below.
78
EN