Haier AC35S2SG1FA Manual De Operacion Y Manual De Instalacion página 28

Installation Procedure
4. Installing the indoor unit
(1) Lift unit so that suspension bolts pass through suspension fittings at
the sides (four places),and slide the unit back.
(2) Fasten the indoor unit into place by tightening-up the special "B" bolts
and the M10 nuts. Make sure that unit is secure and will not shift back
and forth.
For half-concealed installation
When installing the indoor unit in a semi-concealed orientation, make sure
to reinforce the insulation of the unit on all sides. Drops of water may fall
from the unit if it is not thoroughly insulated.
CAUTION
In order to check the drainage, be sure to use a level during installation of
the indoor unit. If the installation site of the indoor unit is not level, water
leakage may occur.
5. Installing the coupler heat insulation
After checking for gas leaks, insulate by wrapping insulation around the two parts (large and
small) of the indoor unit coupling, using the coupler heat insulation. After installling the coupler
heat insulation, wrap both ends with vinyl tape so that there is no gap. Secure both ends ofthe
heat insulation material using nylon fasteners.
Coupler heat insulation(large)
Indoor
unit
When using an auxiliary pipe, make sure that the fastener used is insulated in the same way.
Note
When installing the unit on the floor, fix the four rubber base feet in the accessories on the bottom plate of the unit with four 4x16
screws and 4 flat washers, as the position in the figure.
The bottom plate of the unit.
Coupler pipe
(large)
Coupler pipe
(small)
Coupler heat insulation(small)
Ceiling
indoor unit
26
Ceiling panel
Wall
Glass wool insulate
(10 to 20mm thick)
indoorunit
(Top view)
Nylon fastener (large)
Nylon fastener (small)
rubber base foot
4x16 screw
flat washer
Wall
Wall
Ceiling panel
No gap
Coupler heat
insulation